12/25/2020 0 Comments 3640 Ios Gns3
Step 2: Once you have downloaded the Cisco 3640 series IOS image, open the Preferences window by clicking the Edit and then Preferences in the GNS3 console.Step 3: In the Preferences window, select IOS routers in the left pane.
3640 Ios Gns3 Series IOS ImageTo add a new IOS router template, click New as shown in the following figure. Step 5: Click Browse and navigate to the location where you have downloaded the 3640 IOS image file, and then select it. Step 6: In the IOS Image message box, click Yes to decompress the selected image, and then click Next. Step 7: On the Name and platform page, type a name such as Layer 3 Switch in the Name text box, select the This is an EtherSwitch router check box and then click Next. Step 8: On the Memory page, accept the default memory size or set the desired value, and click Next. Step 10: On the Idle-PC Finder page, click Finish and close the Preferences window. Step 11: You will see that a layer 3 switch in GNS3 console has been added. Step 12: Right-click layer 3 switch ( ESW1 ) and select Start to start it. Step 13: Once it is started, select and right-click again it and select Console to open its console. Step 14: On the ESW1 console, type the following commands to verify that it works as a Layer 3 switch. ESW1config t ESW1(config)hostname Switch1 Switch1(config)exit Switch1vlan database Switch1(vlan)exit Switch1show vlan database Step 15: The following figure shows that the preceding commands are successfully executed on the layer 3 switch that you have added in GNS3.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |